Trim&Bumper Spray Paint

Trim&Bumper Spray Paint renews and restores the OEM Matte Black Finish found on most vehicles. Trim & Bumper Paint is ideal for metal trim, moldings, rearview mirror covers, bumpers and rub strips.

WHERE TO BUY

Trim&Bumper spary Paint TDS

TDS & SDS

7CF-Trim&Bumper spray Paint SDS

TDS & SDS

TRIM & BUMPER SPRAY PAINT FEATURES & BENEFITS

Fast Dry
Renews&Protects
Flexible Finish
Excellent Adhesion

TRIM & BUMPER SPRAY PAINT APPLICATIONS

Used for repairing bumpers, decorative strips, exterior rearview mirrors, and plastic substrates used in ordinary vehicle structures.

DIRECTION OF USING TRIM & BUMPER SPRAY PAINT

Read entire label before using this product.

1
Pre Treatment: Thoroughly remove dirt, grease, oil and water on the surface to be painted.
2
Treatment: The aerosol should have room temperature. Best processing temperature 10 to 25°C. Before use, shake the aerosol for 2 minutes and spray a sample. Distance to the surface to be treated approximately 25 to 30 centimetre.
3
Apply the bumper spray in several thin layers, till the desired result has been achieved. Before applying the next layer, again shake the aerosol.
4
After use, clean the valve (turn aerosol upside down and press the nozzle for approximately 5 seconds).

ATTENTION

1. Please try to use only in the small area for the unknown material, you could use it normally if there is not any abnormal phenomenon after 10min.

2. While spraying the paint, make sure keep the aerosol bottle vertically and don’t slope less than 45 degree with the horizontal direction.

3. Please keep the ventilation is normal, the condition should be dry and shade, no dust, it’s better for the effect of spray paint.

4. Don’t use it in the rainy day or very cold condition.

5. The product is flammable, please keep it in the shade between 0 to 40 centigrade degree, far away from hot source and light fire. Prohibit strong sunshine, pierce and burn the bottle.

6. After using out the paint please keep the bottle upside down then press the valve button for several seconds to release the remained air. Then put the bottle to the safety place.

PHYSICAL & CHEMICAL PROPERTIES OF TRIM & BUMPER SPRAY PAINT

Physical state	liquid
Appearance	Aerosolized Mist
Specific gravity	0.754
Flammability:	Supports Combustion
Evaporation Rate:	Faster than Ether
Vapor Density:	Heavier than Air
Solubility in water	Slight
PH Value	N.D.
Viscosity	N.D.
Vapor Pressure	N.D.